ADC CLI Commands

ip6TunnelParam

The following operations can be performed on “ip6TunnelParam”:

set unset show

set ip6TunnelParam

Sets global parameters of IPv6 tunnels on the Citrix ADC.

Synopsis

set ip6TunnelParam [-srcIP <ipv6_addr null>] [-dropFrag ( YES NO )] [-dropFragCpuThreshold ] [-srcIPRoundRobin ( YES NO )] [-useClientSourceIPv6 ( YES NO )]

Arguments

srcIP Common source IPv6 address for all IPv6 tunnels. Must be a SNIP6 or VIP6 address.

dropFrag Drop any packet that requires fragmentation.

Possible values: YES, NO Default value: NO

dropFragCpuThreshold Threshold value, as a percentage of CPU usage, at which to drop packets that require fragmentation. Applies only if dropFragparameter is set to NO. Minimum value: 1 Maximum value: 100

srcIPRoundRobin Use a different source IPv6 address for each new session through a particular IPv6 tunnel, as determined by round robin selection of one of the SNIP6 addresses. This setting is ignored if a common global source IPv6 address has been specified for all the IPv6 tunnels. This setting does not apply to a tunnel for which a source IPv6 address has been specified.

Possible values: YES, NO Default value: NO

useClientSourceIPv6 Use client source IPv6 address as source IPv6 address for outer tunnel IPv6 header

Possible values: YES, NO Default value: NO

Example

set ip6TunnelParam -srcIP 9901::100 -dropFrag YES -dropFragCpuThreshold 95 -useClientSourceIPv6 YES

unset ip6TunnelParam

Resets the specified global parameters of IPv6 tunnels to their default settings. Refer to the set ip6TunnelParam command for parameter descriptions..Refer to the set ip6TunnelParam command for meanings of the arguments.

Synopsis

unset ip6TunnelParam [-srcIP] [-dropFrag] [-dropFragCpuThreshold] [-srcIPRoundRobin] [-useClientSourceIPv6]

Example

unset ip6TunnelParam -srcIP -dropFrag -dropFragCpuThreshold -useClientSourceIPv6

show ip6TunnelParam

Displays the global settings of IPv6 tunnels on the Citrix ADC.

Synopsis

show ip6TunnelParam

Arguments

Output

srcIP Common source IPv6 address for all IPv6 tunnels. Must be a SNIP6 or VIP6 address.

dropFrag Drop any packet that requires fragmentation.

dropFragCpuThreshold Threshold value, as a percentage of CPU usage, at which to drop packets that require fragmentation. Applies only if dropFragparameter is set to NO.

srcIPRoundRobin Use a different source IPv6 address for each new session through a particular IPv6 tunnel, as determined by round robin selection of one of the SNIP6 addresses. This setting is ignored if a common global source IPv6 address has been specified for all the IPv6 tunnels. This setting does not apply to a tunnel for which a source IPv6 address has been specified.

useClientSourceIPv6 Use client source IPv6 address as source IPv6 address for outer tunnel IPv6 header

Example

Tunnel Source IP: 9901::100 Round Robin of Tunnel Source IP: NO Drop if Fragmentation Needed: YES CPU usage threshold to avoid fragmentation: 95 Use client sourceIP6 as sourceIP6 for outer tunnel IP6 header: YES

ip6TunnelParam