inatparam

Last published : Oct 30, 2026
The following operations can be performed on "inatparam":
unset| set| show|

unset inatparam

Unset the inat parameter.Refer to the set inatparam command for meanings of the arguments.

Synopsis

unset inatparam [-nat46v6Prefix ]

Example

unset inatparam -nat46v6Prefix -td 1

set inatparam

Set the inat parameter

Synopsis

set inatparam [-nat46v6Prefix <ipv6_addr|*> ]

Arguments

nat46v6Prefix The prefix used for translating packets received from private IPv6 servers into IPv4 packets. This prefix has a length of 96 bits (128-32 = 96). The IPv6 servers embed the destination IP address of the IPv4 servers or hosts in the last 32 bits of the destination IP address field of the IPv6 packets. The first 96 bits of the destination IP address field are set as the IPv6 NAT prefix. IPv6 packets addressed to this prefix have to be routed to the Citrix ADC to ensure that the IPv6-IPv4 translation is done by the appliance.
td Integer value that uniquely identifies the traffic domain in which you want to configure the entity. If you do not specify an ID, the entity becomes part of the default traffic domain, which has an ID of 0. Default value: 0 Minimum value: 0 Maximum value: 4094
nat46IgnoreTOS Ignore TOS.
Possible values: YES, NO Default value: NO
nat46ZeroCheckSum Calculate checksum for UDP packets with zero checksum
Possible values: ENABLED, DISABLED Default value: ENABLED
nat46v6Mtu MTU setting for the IPv6 side. If the incoming IPv4 packet greater than this, either fragment or send icmp need fragmentation error. Default value: 1280 Minimum value: 1280 Maximum value: 9216
nat46FragHeader When disabled, translator will not insert IPv6 fragmentation header for non fragmented IPv4 packets
Possible values: ENABLED, DISABLED Default value: ENABLED

Example

set inat parameter -nat46ignoretos YES

show inatparam

Show the inat parameters.

Synopsis

show inatparam

Arguments

td Integer value that uniquely identifies the traffic domain in which you want to configure the entity. If you do not specify an ID, the entity becomes part of the default traffic domain, which has an ID of 0. Default value: 0 Minimum value: 0 Maximum value: 4094

Output

nat46v6Prefix The prefix used for translating packets received from private IPv6 servers into IPv4 packets. This prefix has a length of 96 bits (128-32 = 96). The IPv6 servers embed the destination IP address of the IPv4 servers or hosts in the last 32 bits of the destination IP address field of the IPv6 packets. The first 96 bits of the destination IP address field are set as the IPv6 NAT prefix. IPv6 packets addressed to this prefix have to be routed to the Citrix ADC to ensure that the IPv6-IPv4 translation is done by the appliance.
nat46IgnoreTOS Ignore TOS.
nat46ZeroCheckSum Calculate checksum for UDP packets with zero checksum
nat46v6Mtu MTU setting for the IPv6 side. If the incoming IPv4 packet greater than this, either fragment or send icmp need fragmentation error.
nat46FragHeader When disabled, translator will not insert IPv6 fragmentation header for non fragmented IPv4 packets
setcmdflag devno count stateflag

Example

show inat params