L4Param
The following operations can be performed on "L4Param":
unset L4Param
Use this command to remove L4Param settings.Refer to the set L4Param command for meanings of the arguments.
set L4Param
Set Layer 4 related global settings on the Citrix ADC
Arguments
l2ConnMethod Layer 2 connection method based on the combination of channel number, MAC address and VLAN. It is tuned with l2conn param of lb vserver. If l2conn of lb vserver is ON then method specified here will be used to identify a connection in addition to the 4-tuple (<source IP>:<source port>::<destination IP>:<destination port>).
Possible values: Channel, Vlan, VlanChannel, Mac, MacChannel, MacVlan, MacVlanChannel Default value: MacVlanChannel
l4switch In L4 switch topology, always clients and servers are on the same side. Enable l4switch to allow such connections.
Possible values: ENABLED, DISABLED Default value: DISABLED
Example
set l4param
show L4Param
Displays the settings of global Layer 4 parameters.
Synopsis
show L4Param
Arguments
Output
l2ConnMethod Layer 2 connection method based on the combination of channel number, MAC address and VLAN. It is tuned with l2conn param of lb vserver. If l2conn of lb vserver is ON then method specified here will be used to identify a connection in addition to the 4-tuple (<source IP>:<source port>::<destination IP>:<destination port>).
l4switch In L4 switch topology, always clients and servers are on the same side. Enable l4switch to allow such connections.