nat64param
The following operations can be performed on "nat64param":
unset nat64param
Use this command to remove nat64param settings.Refer to the set nat64param command for meanings of the arguments.
show nat64param
Show the nat64 parameters.
Arguments
td Integer value that uniquely identifies the traffic domain in which you want to configure the entity. If you do not specify an ID, the entity becomes part of the default traffic domain, which has an ID of 0. Default value: 0 Minimum value: 0 Maximum value: 4094
Output
nat64IgnoreTOS Ignore TOS.
nat64ZeroCheckSum Calculate checksum for UDP packets with zero checksum
nat64v6Mtu MTU setting for the IPv6 side. If the incoming IPv4 packet greater than this, either fragment or send icmp need fragmentation error.
nat64FragHeader When disabled, translator will not insert IPv6 fragmentation header for non fragmented IPv4 packets
devno count stateflag
Example
show nat64param
set nat64param
Set the nat64 parameter
Arguments
td Integer value that uniquely identifies the traffic domain in which you want to configure the entity. If you do not specify an ID, the entity becomes part of the default traffic domain, which has an ID of 0. Default value: 0 Minimum value: 0 Maximum value: 4094
nat64IgnoreTOS Ignore TOS.
Possible values: YES, NO Default value: NO
nat64ZeroCheckSum Calculate checksum for UDP packets with zero checksum
Possible values: ENABLED, DISABLED Default value: ENABLED
nat64v6Mtu MTU setting for the IPv6 side. If the incoming IPv4 packet greater than this, either fragment or send icmp need fragmentation error. Default value: 1280 Minimum value: 1280 Maximum value: 9216
nat64FragHeader When disabled, translator will not insert IPv6 fragmentation header for non fragmented IPv4 packets
Possible values: ENABLED, DISABLED Default value: ENABLED
Example
set nat64param -nat64ignoretos YES