ADC CLI Commands

ica-parameter

August 18, 2023

Contributed by:

The following operations can be performed on “ica-parameter”:

unset

set

show

unset ica parameter

Use this command to remove ica parameter settings.Refer to the set ica parameter command for meanings of the arguments.

Synopsis

unset ica parameter [-EnableSRonHAFailover] [-HDXInsightNonNSAP] [-EDTPmtudDF] [-EDTPmtudDFTimeout] [-L7LatencyFrequency]

set ica parameter

Sets the global ica configuration parameter

Synopsis

set ica parameter [-EnableSRonHAFailover ( YES

NO )] [-HDXInsightNonNSAP ( YES

NO )] [-EDTPmtudDF ( ENABLED

DISABLED )] [-EDTPmtudDFTimeout ] [-L7LatencyFrequency ]

Arguments

EnableSRonHAFailover Enable/Disable Session Reliability on HA failover. The default value is No

Possible values: YES, NO Default value: NO

HDXInsightNonNSAP Enable/Disable HDXInsight for Non NSAP ICA Sessions. The default value is Yes

Possible values: YES, NO Default value: YES

EDTPmtudDF Enable/Disable DF enforcement for EDT PMTUD Control Blocks

Possible values: ENABLED, DISABLED Default value: ENABLED

EDTPmtudDFTimeout DF enforcement timeout for EDTPMTUDDF Default value: 100 Minimum value: 10 Maximum value: 65535

L7LatencyFrequency Specify the time interval/period for which L7 Client Latency value is to be calculated. By default, L7 Client Latency is calculated for every packet. The default value is 0 Default value: 0 Minimum value: 0 Maximum value: 60

Example

set ica parameter -EnableSRonHAFailover YES

show ica parameter

Displays the global ica configuration

Synopsis

show ica parameter

Arguments

Output

EnableSRonHAFailover Enable/Disable Session Reliability on HA failover. The default value is No

HDXInsightNonNSAP Enable/Disable HDXInsight for Non NSAP ICA Sessions. The default value is Yes

EDTPmtudDF Enable/Disable DF enforcement for EDT PMTUD Control Blocks

EDTPmtudDFTimeout DF enforcement timeout for EDTPMTUDDF

builtin Indicates that the ICA parameter is a built-in (SYSTEM INTERNAL) type.

L7LatencyFrequency Specify the time interval/period for which L7 Client Latency value is to be calculated. By default, L7 Client Latency is calculated for every packet. The default value is 0

Example

show ica parameter

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

ica-parameter

August 18, 2023

Contributed by:

August 18, 2023

Contributed by:

ica-parameter

unset ica parameter

Synopsis

set ica parameter

Synopsis

Arguments

Example

show ica parameter

Synopsis

Arguments

Output

Example

In this article