ADC CLI Commands

inatparam

May 28, 2024

Contributed by:

The following operations can be performed on “inatparam”:

unset

show

set

unset inatparam

Unset the inat parameter.Refer to the set inatparam command for meanings of the arguments.

Synopsis

unset inatparam [-nat46v6Prefix [-td ]]

Example

unset inatparam -nat46v6Prefix -td 1

show inatparam

Show the inat parameters.

Synopsis

show inatparam [-td ]

Arguments

td Integer value that uniquely identifies the traffic domain in which you want to configure the entity. If you do not specify an ID, the entity becomes part of the default traffic domain, which has an ID of 0. Default value: 0 Minimum value: 0 Maximum value: 4094

Output

nat46v6Prefix The prefix used for translating packets received from private IPv6 servers into IPv4 packets. This prefix has a length of 96 bits (128-32 = 96). The IPv6 servers embed the destination IP address of the IPv4 servers or hosts in the last 32 bits of the destination IP address field of the IPv6 packets. The first 96 bits of the destination IP address field are set as the IPv6 NAT prefix. IPv6 packets addressed to this prefix have to be routed to the Citrix ADC to ensure that the IPv6-IPv4 translation is done by the appliance.

nat46IgnoreTOS Ignore TOS.

nat46ZeroCheckSum Calculate checksum for UDP packets with zero checksum

nat46v6Mtu MTU setting for the IPv6 side. If the incoming IPv4 packet greater than this, either fragment or send icmp need fragmentation error.

nat46FragHeader When disabled, translator will not insert IPv6 fragmentation header for non fragmented IPv4 packets

setcmdflag devno count stateflag

Example

show inat params

set inatparam

Set the inat parameter

Synopsis

set inatparam [-nat46v6Prefix <ipv6_addr

*> [-td ]] [-nat46IgnoreTOS ( YES

NO )] [-nat46ZeroCheckSum ( ENABLED

DISABLED )] [-nat46v6Mtu ] [-nat46FragHeader ( ENABLED

DISABLED )]

Arguments

nat46IgnoreTOS Ignore TOS.

Possible values: YES, NO Default value: NO

nat46ZeroCheckSum Calculate checksum for UDP packets with zero checksum

Possible values: ENABLED, DISABLED Default value: ENABLED

nat46v6Mtu MTU setting for the IPv6 side. If the incoming IPv4 packet greater than this, either fragment or send icmp need fragmentation error. Default value: 1280 Minimum value: 1280 Maximum value: 9216

nat46FragHeader When disabled, translator will not insert IPv6 fragmentation header for non fragmented IPv4 packets

Possible values: ENABLED, DISABLED Default value: ENABLED

Example

set inat parameter -nat46ignoretos YES

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

inatparam

May 28, 2024

Contributed by:

May 28, 2024

Contributed by:

inatparam

unset inatparam

Synopsis

Example

show inatparam

Synopsis

Arguments

Output

Example

set inatparam

Synopsis

Arguments

Example

In this article