ADC CLI Commands

lsn-parameter

May 28, 2024

Contributed by:

The following operations can be performed on “lsn-parameter”:

unset lsn parameter

Use this command to remove lsn parameter settings.Refer to the set lsn parameter command for meanings of the arguments.NOTE: This command is deprecated.

Synopsis

show lsn parameter

Display the global configuration of the LSN. NOTE: This command is deprecated.LSN related configuration commands are being deprecated will be removed in a future release

Synopsis

Arguments

Output

memLimitActive Amount of actual memory reserved for the LSN feature.

The amount of active memory for the LSN feature might be less than the configured memory, because the available memory is shared across features.

maxMemLimit Maximum amount of Citrix ADC memory that can be reserved for the LSN feature.

memLimit Amount of Citrix ADC memory to reserve for the LSN feature, in multiples of 2MB.

Note: If you later reduce the value of this parameter, the amount of active memory is not reduced. Changing the configured memory limit can only increase the amount of active memory. This command is deprecated, use ‘set extendedmemoryparam -memlimit’ instead.

sessionSync Synchronize all LSN sessions with the secondary node in a high availability (HA) deployment (global synchronization). After a failover, established TCP connections and UDP packet flows are kept active and resumed on the secondary node (new primary).

The global session synchronization parameter and session synchronization parameters (group level) of all LSN groups are enabled by default.

For a group, when both the global level and the group level LSN session synchronization parameters are enabled, the primary node synchronizes information of all LSN sessions related to this LSN group with the secondary node.

subscrSessionRemoval LSN global setting for controlling subscriber aware session removal, when this is enabled, when ever the subscriber info is deleted from subscriber database, sessions corresponding to that subscriber will be removed. if this setting is disabled, subscriber sessions will be timed out as per the idle time out settings.

set lsn parameter

Modify the global configuration of the LSN. NOTE: This command is deprecated.

Synopsis

Arguments

The global session synchronization parameter and session synchronization parameters (group level) of all LSN groups are enabled by default.

Possible values: ENABLED, DISABLED Default value: ENABLED

Possible values: ENABLED, DISABLED Default value: DISABLED

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

lsn-parameter

May 28, 2024

Contributed by:

May 28, 2024

Contributed by:

lsn-parameter

unset lsn parameter

Synopsis

show lsn parameter

Synopsis

Arguments

Output

set lsn parameter

Synopsis

Arguments

In this article